|Listed in category:
Have one to sell?

1965-1966 Plymouth Fury III HEATER CONTROL Unit

Condition:
Used
good
Price:
US $39.95
ApproximatelyRM 188.28
Pickup:
Free local pickup from West Granby, Connecticut, United States. See detailsfor pickup
Postage:
Free Economy Shipping. See detailsfor shipping
Located in: West Granby, Connecticut, United States
Delivery:
Estimated between Wed, 26 Jun and Fri, 28 Jun to 43230
Delivery time is estimated using our proprietary method which is based on the buyer's proximity to the item location, the postage service selected, the seller's postage history, and other factors. Delivery times may vary, especially during peak periods.
Coverage:
Read item description or contact seller for details. See all detailsSee all details on coverage
(Not eligible for eBay purchase protection programmes)

Seller information

Seller assumes all responsibility for this listing.
eBay item number:284156122846

Item specifics

Condition
Used
A vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections. See all condition definitionsopens in a new window or tab
Seller Notes
“good”
Country/Region of Manufacture
United States
Surface Finish
ORIGINAL OEM PART
Brand
Mopar
Warranty
No Warranty

Item description from the seller

granbys-ed

granbys-ed

100% positive feedback
879 items sold
Usually responds within 24 hours

Detailed Seller Ratings

Average for the last 12 months

Accurate description
5.0
Reasonable shipping cost
4.6
Shipping speed
5.0
Communication
5.0

Seller feedback (515)

n***o (62)- Feedback left by buyer.
Past month
Verified purchase
@granbys-ed mentioned it might have a bad ignition coil. I had a new one waiting. The new one was bad, but I cleaned the rust off the old coil and it works fine. Filled the tanks and reconnected the fuel line and it started right up. Put on a new bar and full chisel chain and it's ready to go. Slight adjustment on the high speed for the altitude here and it runs strong. Good transition. Good compression. Now what do I do with the engine I had rebuilt to go in it?
n***s (390)- Feedback left by buyer.
Past month
Verified purchase
Thank you
a***h (554)- Feedback left by buyer.
Past month
Verified purchase
Would do business with again