|Listed in category:
Have one to sell?

4 APPLIANCE WIRE WHEELS 3 BAR SPINNERS CENTER CAPS RED FLAGS SET SCR

Condition:
New
8 available / 13 sold
Price:
US $89.95
ApproximatelyRM 423.80
Postage:
Free Expedited Postage. See detailsfor shipping
Located in: Mira Loma, California, United States
Delivery:
Estimated between Fri, 28 Jun and Wed, 3 Jul to 43230
Delivery time is estimated using our proprietary method which is based on the buyer's proximity to the item location, the postage service selected, the seller's postage history, and other factors. Delivery times may vary, especially during peak periods.
Returns:
30 days return. Buyer pays for return shipping. See details- for more information about returns
Coverage:
Read item description or contact seller for details. See all detailsSee all details on coverage
(Not eligible for eBay purchase protection programmes)

Shop with confidence

eBay Premium Service
Trusted seller, fast shipping, and easy returns. 

Seller information

Registered as a Business Seller
Seller assumes all responsibility for this listing.
eBay item number:255793718812
Last updated on Dec 14, 2023 12:19:56 MYTView all revisionsView all revisions

Item specifics

Condition
New: A vehicle is considered new if it is purchased directly from a new car franchise dealer and has ...
Brand
LUGNUTKINGI
Interchange Part Number
LK35APL
Manufacturer Warranty
Yes
Number in Pack
4
Manufacturer Part Number
LK35APL
Placement on Vehicle
Front, Left, Lower, Rear, Right, Upper

Item description from the seller

LUG NUT KING IV

LUG NUT KING IV

99.7% positive feedback
73K items sold

Seller feedback (33,739)

-***i (345)- Feedback left by buyer.
More than a year ago
Verified purchase
Fast shipping
t***t (711)- Feedback left by buyer.
More than a year ago
Verified purchase
good good
e***h (435)- Feedback left by buyer.
More than a year ago
Verified purchase
These look great! However, I replaced the screws with hex head as opposed to slotted, to make it easier to tighten. The screws should be hardened with a point on them. I found the insert slips out when crewing on the spinner. I think a point on the end would help and hardened screws would allow more torque when tightening the hub down.
See all feedback